Forum > Mandalorian Armor Planning
Jesse's WIP
Jesse Libarra:
Thanks, all. :) I'm thinking I may have to trim the collar plate a little...
Ordeyn:
--- Quote from: Jesse Libarra on Feb 26, 2012, 09:38 AM ---Thanks, all. :) I'm thinking I may have to trim the collar plate a little...
--- End quote ---
I trimmed my mine. I couldn't move my arms up very far due to the width of the collar plate. But because I trimmed the collar plate I also took off some of the chest plates too so they match up still.
Your concept pics look great! :D Keep up the good work.
Jesse Libarra:
--- Quote from: Ordeyn on Feb 26, 2012, 10:03 AM ---I trimmed my mine. I couldn't move my arms up very far due to the width of the collar plate. But because I trimmed the collar plate I also took off some of the chest plates too so they match up still.
--- End quote ---
--- Quote ---Your concept pics look great! :D Keep up the good work.
--- End quote ---
Thank you, Ordeyn. :)
Jesse Libarra:
So, it's been forever since I posted on this, so I'm just going to bump this back up. :)
I'm looking at doing the angled plates, and I was wondering, how would you go about shaping the angled plates? Ideas and suggestions are most welcome. :)
Jesse Libarra:
all righty, I thought up another question. :D
I've been reading through the various threads regarding helmet sizing and buying, and I've been trying to figure out the sizing ratio. I'm still scratching my head about the '1:1' or the '2:1' ratios. Is there a specific mathematical formula to this, or is just a relative thing? Also, I was thinking I'd need to be absolutely positive that the helmet was the right size before I spent all this money.
I've been tossing around the idea getting of the Jango 2 piece ('cause I'm small [like, 5 foot nothing]) and I was wondering if you can only buy it online, or if there's a place to go and try on different helmets. (That may just be wishful thinking on my part)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version